MULTISPEC ROLLER APPLICATION OVER INTERIOR CONCRETE FLOORS
(Garages and Basements)

Step 1 / Required – Prep and Prime
Etch and neutralize concrete. Clean floor thoroughly. Using a short nap roller or brush, apply one coat of Multispec Basecoat (SE1 White for Multispec WaterColors or SE2 Gray for Multispec Stone Accents).

Step 2 / Required – Apply Multispec
Using a Speckle Effects special open cell reticulated foam roller cover, roll Multispec over basecoated surface. Load roller fully, roll slowly and gently to minimize spattering and achieve optimal coverage.

Step 3 / Required – Apply Clear Topcoat
Apply 2 to 3 coats of high performance, topcoat such as Plioshield^TM. First coat will seal Multispec to facilitate subsequent cleaning. Second and third coats will enhance durability and/or impart more gloss.

Note

• Multispec will be easier to repair and touch-up if only one coat of clear topcoat (sealer) is applied.
• When using Multispec WaterColors which do not contain white flecks, SE1 White Basecoat should be tinted to match predominant fleck color in WaterColors.
• Allow individual coats to dry thoroughly before recoating.
• Follow manufacturer’s label instructions and application guidelines for coating, equipment and tools.
• For a smooth finish, spray apply Multispec. Refer to spray application guidelines.