MULTICOLOR SPECIALTIES, INC. 800/536-5456 Order: 800/362-6617

MULTISPEC ROLLER APPLICATION OVER EXPOSED EXTERIOR, VERTICAL MASONRY SURFACES
(Concrete, Block or Stucco Walls)

Step 1 / Required or Optional - Depending on Surface to be Covered - Prep and Prime
Clean surface thoroughly. Using a short nap roller or brush, apply one coat of Multispec textured, adhesion promoting basecoat (SE1 White for Multispec WaterColors or SE2 Gray for Stone Accents). Basecoat improves Multispec rolling properties particularly over smooth or previously painted surfaces. Textured/absorbent surfaces may not require basecoat.

Step 2 / Required – Apply Multispec
Using a Speckle Effects special open cell reticulated foam roller cover, roll Multispec over the basecoated surface. Load roller fully, roll slowly and gently to minimize spattering and achieve optimal coverage. Use a Speckle Effects 3” roller cover or corner roller to cut-in and paint corners.

Step 3 / Optional – Apply Clear Topcoat
Apply 2 to 3 coats of high performance, exterior grade, clear water repellent protective topcoat such as Plioshield^TM. First coat will seal the Multispec and additional coats will provide greater protection from sunlight and the elements.

 Note

• Allow individual coats to dry thoroughly before recoating.
• When using Multispec WaterColors which do not contain white flecks, SE1 White Basecoat should be tinted to match predominant fleck color in WaterColors.
• Follow manufacturer’s label instructions and application guidelines for coatings, equipment and tools.
• For a smooth finish; spray apply Multispec. Refer to spray application guidelines